Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
22.
Install the drive cable assembly into the guide rail as follows:
a.
Insert the inside front shoe into the rail. Then push the lift mechanism about one inch into the rail.
b.
Insert the inside check block onto the pin on the lift link shoe, so that the groove in the check block fits over the sliding pin on the shoe.
Then guide the check block and lift mechanism into the rail about 1.5 inches. Be sure that the guide pin on the lift mechanism remains above
the rail.
c.
Mount the outer link shoe on the lower outside pin of the lift mechanism. Guide the shoe and lift mechanism into the rail.
Gently push the drive cable assembly into the guide rail a little at a time.
d.
Attach the drive cable as shown. Slide the lift mechanism forward.
e.
Gently rotate the drive cable assembly over the top of the "tab" in the guide rail.
f.
Slide the lift mechanism to the forwardmost position.
