Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
1. Install the vacuum hose with the white-marked sections facing up.
2. Insert securely and completely until the vacuum hose at the engine side contacts the edge of the hexagonal part of the fitting, and then secure
with the hose clamp.
>>B<< CLEARANCE ADJUSTMENT BETWEEN BRAKE BOOSTER PUSHROD AND PRIMARY PISTON
1. Using a hand vacuum pump, apply a negative pressure of - 66.7 kPa (19.6 inch Hg) to the brake booster.
2. Measure protruding length A at the pushrod.
Standard value (A): 10.28 - 10.53 mm (0.404 - 0.415 inch)
3. If the protruding length is not within the standard value range, adjust by changing the pushrod length by turning the end of the pushrod.
With ABS
Refer to With Basic Brake System.
