Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
CAUTION: Be careful not to damage or deform the plug guides when removing the cylinder head bolts. Plug guides cannot be replaced
separately.
Using special tool MB991654, loosen the bolts in two or three steps in the order of the numbers shown in the illustration, then remove the cylinder
head assembly.
INSTALLATION SERVICE POINTS
>>A<< CYLINDER HEAD GASKET INSTALLATION
1. Wipe off all oil and grease from the gasket mounting surface.
2. Match the shapes of the cylinder head holes with their respective cylinder head gasket holes.
>>B<< CYLINDER HEAD ASSEMBLY INSTALLATION
1. When installing the cylinder head bolts, the length below the head of the bolts should be within the limit. If it is outside the limit, replace the
bolts.
Limit (A): 99.4 mm (3.91 inches)
2. Apply a small amount of engine oil to the thread section and the washer of the cylinder head bolt.
CAUTION:
-
Always tighten cylinder head bolts at a 90 degree angle. If it is less than 90 degree angle, the bolt will loosen.
-
If it is more than 90 degree angle, remove the head bolt and repeat the procedure from step 1.
