Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
Wheel Hub: Testing and Inspection
End Play Check
Front
CHECK
1. Remove the disc brake caliper and suspend it with a wire.
2. Remove the brake disc from the front hub.
3. Attach a dial gauge as shown in the illustration, and then measure the end play while moving the hub in the axial direction.
Limit: 0.05 mm (0.002 inch)
4. If end play exceeds the limit, replace the front hub assembly.
Rear
For further information regarding this component and the system that it is a part of, please refer to Wheel Bearing; Testing and Inspection; Procedures.
