Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 3. Check the wiring harness between sunroof motor assembly connector D-06 and fusible link (5).
NOTE: Also check intermediate connectors C-31 and C-89. If intermediate connector C-31 or C-89 is damaged, repair or replace the connector as
described in Harness Connector Inspection.
Q: Is the wiring harness between sunroof motor assembly connector D-06 and fusible link (5) in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. The system should communicate with the sunroof motor assembly (sunroof-ECU) normally.
STEP 4. Check sunroof motor assembly connector D-06 by backprobing in order to the battery line of the power supply circuit to the sunroof
motor assembly.
1. Measure at sunroof motor assembly connector D-06 without disconnecting it.
2. Measure the voltage between terminal 3 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 7.
NO: Go to Step 5.
