Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 10. Check the wiring harness between power window main switch connector E-12 and power window sub-switch connector E-05.
NOTE: Also check intermediate connectors C-91 and C-95. If intermediate connectors C-91 or C-95 is damaged, repair or replace the connector as
described in Harness Connector Inspection.
Q: Is the wiring harness between power window main switch connector E-12 and power sub-switch connector E-05 in good condition?
YES: Replace the power window main switch. When the power window sub-switch is operated, the power window (RH) should open or close
normally.
NO: Repair the wiring harness. When the power window sub-switch is operated, the power window (RH) should open or close normally.
STEP 11. Measure at power window sub switch connector E-05 in order to check the ground circuit to the power window sub switch.
1. Disconnect power window sub-switch connector E-05, and measure at the harness side.
2. Measure the resistance value between terminal 5 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 14.
NO: Go to Step 12.
