mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2021 > < Initial Inspection and Diagnostic Overview|Page 2019
Page 104
background image

STEP 13. Check the sunroof switch.

Q: Does the check above meet the table?

YES: Go to Step 14.

NO: Replace the sunroof switch. The sunroof should work normally.

STEP 14. Check the sunroof switch ground circuit at the sunroof switch connector D-05.

1. Disconnect the sunroof switch connector D-05 and measure at the harness side.

2. Measure the resistance between terminal 4 and ground. 

-

The measured value should be 2 ohm or less.

Q: Does the measured resistance value correspond with this range?

YES: Go to Step 17.

NO: Go to Step 15.

Initial Inspection and Diagnostic Overview|Page 2021 > < Initial Inspection and Diagnostic Overview|Page 2019