mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2050 > < Initial Inspection and Diagnostic Overview|Page 2048
Page 133
background image

STEP 4. Check the windshield washer motor.

1. Disconnect windshield washer motor connector A-33, and check at windshield washer motor connector side.
2. Fill the windshield washer tank with washer fluid.
3. When battery voltage is applied between terminals 1 and 2, washer fluid should gush out.

Q: Does the windshield washer motor operate normally?

YES: Go to Step 5.

NO: Replace the windshield washer motor. Check that the windshield washer works normally.

STEP 5. Check at windshield washer motor connector A-33 to check the windshield washer motor ground circuit.

1. Disconnect windshield washer motor connector A-33, and measure at the wiring harness side.

2. Measure the resistance value between terminal 2 and ground.

-

The measured value should be 2 ohm or less.

Q: Does the measured resistance value correspond with this range?

YES: Go to Step 8.

NO: Go to Step 6.

STEP 6. Check windshield washer motor connector A-33 for damage.

Q: Is windshield washer motor connector A-33 in good condition?

YES: Go to Step 7.

NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the windshield washer works normally.

Initial Inspection and Diagnostic Overview|Page 2050 > < Initial Inspection and Diagnostic Overview|Page 2048