mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2057 > < Initial Inspection and Diagnostic Overview|Page 2055
Page 140
background image

STEP 5. Check the harness wires between rear wiper motor connector F-07 and ETACS-ECU connector C-119.

NOTE:  After checking intermediate connector F-24 and junction block connector C-101, check the wires. If intermediate connector F-24 and junction
block connector C-101 are damaged, repair or replace them. Refer to Harness Connector Inspection. 

Q: Are the harness wires between rear wiper motor connector F-07 and ETACS-ECU connector C-119 in good condition?

YES: Replace the ETACS-ECU. The rear wiper should work normally.

NO: Repair them. The rear wiper should work normally.

Inspection Procedure H-2

Rear Wiper and Washer: Rear Wiper does not Stop at the Predetermined Park Position.

Initial Inspection and Diagnostic Overview|Page 2057 > < Initial Inspection and Diagnostic Overview|Page 2055