Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
3. Select "REAR WIPER - REAR WIPER" (FUNCTION DIAG.), and check that normal conditions are displayed on the items described in the
table.
Q: Are normal conditions displayed?
YES: Go to Step 3.
NO: Refer to Inspection Procedure O-8 "ETACS-ECU does not receive a signal from the rear washer switch."
STEP 3. Check the rear washer motor.
1. Disconnect rear washer motor connector A-34.
2. Fill the washer tank with washer fluid.
3. When battery voltage is applied between terminals 1 and 2, washer fluid should gush out.
Q: Does the rear washer motor operate normally?
YES: Go to Step 4.
NO: Replace the rear washer motor. Check that the rear washer works normally.
STEP 4. Check at rear washer motor connector A-34 to check the rear washer motor ground circuit.
1. Disconnect rear washer motor connector A-34, and measure at the wiring harness side.
2. Measure the resistance value between terminal 2 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 7.
NO: Go to Step 5.
