Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 25. Measure at rear combination light (LH) connector F-17 in order to check the ground circuit to the rear combination light (LH).
1. Disconnect rear combination light (LH) connector F-17, and measure at the wiring harness side.
2. Measure the resistance value between terminal 5 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 28.
NO: Go to Step 26.
Part 2
Headlight, Tail Light: Tail Lights, the Position Lights, the Side Marker Light or the License Plate Lights do not Illuminate (Continued).
STEP 26. Check rear combination light (LH) connector F-17 for damage.
Q: Is rear combination light (LH) connector F-17 in good condition?
YES: Go to Step 27.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the tail light (LH) illuminates normally.
