Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
Q: Are front combination light (LH) connector A-26 and ETACS-ECU connector C-119 in good condition?
YES: Go to Step 7.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the turn-signal lights illuminate normally.
STEP 7. Check the wiring harness between front combination light (LH) connector A-26 and ETACS-ECU connector C-119.
NOTE: Also check junction block connector C-112 and intermediate connector C-89. If junction block connector C-112 or intermediate connector C-89
is damaged, repair or replace the connector as described in Harness Connector Inspection.
Q: Is the wiring harness between front combination light (LH) connector A-26 and ETACS-ECU connector C-119 in good condition?
YES: Replace the front combination light socket (LH).Check that the turn-signal lights illuminate normally.
NO: Repair the wiring harness. Check that the turn-signal lights illuminate normally.
STEP 8. Check the front turn-signal light bulb (RH).
1. Remove the front turn-signal (RH) light bulb.
2. Check that the front turn-signal light bulb (RH) is not broken.
Q: Is the front turn-signal (RH) light bulb in good condition?
YES: Go to Step 9.
NO: Replace the front turn-signal (RH) light bulb. Check that the turn-signal lights illuminate normally.
STEP 9. Measure at front combination light (RH) connector A-32 in order to check the ground circuit to the front combination light (RH).
1. Disconnect front combination light (RH) connector A-32, and measure at the wiring harness side.
