Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 19. Check the wiring harness between rear combination light (LH) connector F-17 and ETACS-ECU connector C-119.
NOTE: Also check junction block connector C-101. If junction block connector C-101 is damaged, repair or replace the connector as described in
Harness Connector Inspection.
Q: Is the wiring harness between rear combination light (LH) connector F-17 and ETACS-ECU connector C-119 in good condition?
YES: Replace the rear combination light socket assembly (LH). Check that the turn-signal lights illuminate normally.
NO: Repair the wiring harness. Check that the turn-signal lights illuminate normally.
STEP 20. Check the rear turn-signal light bulb (RH).
1. Remove the rear turn-signal (RH) light bulb,
2. Check that the rear turn-signal light bulb (RH) is not broken.
Q: Is the rear turn-signal (RH) light bulb in good condition?
YES: Go to Step 21.
NO: Replace the rear turn-signal (RH) light bulb. Check that the turn-signal lights illuminate normally.
STEP 21. Measure at rear combination light (RH) connector F-09 in order to check the ground circuit to the rear turn-signal light (RH).
1. Disconnect rear combination light (RH) connector F-09, and measure at the wiring harness side.
2. Measure the resistance value between terminal 5 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
