mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2182 > < Initial Inspection and Diagnostic Overview|Page 2180
Page 265
background image

Connectors

CIRCUIT OPERATION

The ETACS-ECU operates the dome light according to the following signals:

-

Ignition switch (IG1): ON or OFF

-

Key reminder switch: ON or OFF

-

Front door switch: ON or OFF

-

Driver's door lock actuator switch: LOCK or UNLOCK

TECHNICAL DESCRIPTION (COMMENT)

Is the dome light does not flash normally, a burned-out dome light bulb, the input circuits from the switches described in "CIRCUIT OPERATION", the
power supply line to the switches or the ETACS-ECU may be defective.

TROUBLESHOOTING HINTS

-

Malfunction of the key reminder switch

-

Malfunction of the door switch

-

Malfunction of the driver's door lock actuator switch

-

Malfunction of the dome light

-

Malfunction of the ETACS-ECU

-

Damaged harness wires or connectors

DIAGNOSIS

Required Special Tools:

-

MB991223: Test Harness Set

-

MB991502: Scan Tool (MUT-II)

STEP 1. Check which of the dome light, the luggage compartment light <ECLIPSE> or the trunk light <ECLIPSE SPYDER> does not
illuminate normally.

Q: Which of the dome light, the luggage compartment light <ECLIPSE> or the trunk light <ECLIPSE SPYDER> fail to illuminate normally? 

Initial Inspection and Diagnostic Overview|Page 2182 > < Initial Inspection and Diagnostic Overview|Page 2180