mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2183 > < Initial Inspection and Diagnostic Overview|Page 2181
Page 266
background image

dome light does not illuminate normally; Go to Step 2. 
luggage compartment light <ECLIPSE> : Go to Step 8. 
trunk light <ECLIPSE SPYDER> : Go to Step 15.

STEP 2. Check the dome light bulb.

Q: Is the dome light bulb in good condition?

YES: Go to Step 3.

NO: Replace the bulb. Check that the dome light illuminates normally.

STEP 3. Measure at dome light connector D-04 <ECLIPSE-vehicles without sunroof> or D-03 <ECLIPSE SPYDER, ECLIPSE-vehicles with
sunroof, without vanity mirror light> or D-25 <ECLIPSE-vehicles with sunroof and vanity mirror light> in order to check the ETACS-ECU
line of the power supply to the dome light.

1. Disconnect dome light connector D-04 <ECLIPSE-vehicles without sunroof> or D-03 <ECLIPSE SPYDER, ECLIPSE-vehicles with sunroof,

without vanity mirror light> or D-25 <ECLIPSE-vehicles with sunroof and vanity mirror light>, and measure at the wiring harness side.

2. Measure the voltage between terminal 3 <ECLIPSE- vehicles without sunroof>, 7 <ECLIPSE-vehicles with sunroof> or 2 <ECLIPSE SPYDER>

and ground. 
-

The measured value should be approximately 12 volts (battery positive voltage).

Q: Does the measured voltage correspond with this range?

YES: Go to Step 6.

NO: Go to Step 4.

Initial Inspection and Diagnostic Overview|Page 2183 > < Initial Inspection and Diagnostic Overview|Page 2181