mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2191 > < Initial Inspection and Diagnostic Overview|Page 2189
Page 274
background image

Q: Is the luggage compartment bulb in good condition?

YES: Go to Step 16.

NO: Replace the bulb. Check that the trunk lights illuminate normally.

STEP 16. Measure at trunk light connector F-21 in order to check the ETACS-ECU line of the power supply to the trunk light.

1. Disconnect trunk light connector F-21, and measure at the wiring harness side.

2. Measure the voltage between terminal 1 and ground. 

-

The measured value should be approximately 12 volts (battery positive voltage).

Q: Does the measured voltage correspond with this range?

YES: Go to Step 19.

NO: Go to Step 17.

STEP 17. Check trunk light connector F-21 and ETACS-ECU connector C-119 for damage.

Q: Are trunk light connector F-21 and ETACS-ECU connector C-119 in good condition?

YES: Go to Step 18.

NO: Repair or replace the connector. Refer to Harness Connector Inspection. Check that the trunk lights illuminate normally.

Initial Inspection and Diagnostic Overview|Page 2191 > < Initial Inspection and Diagnostic Overview|Page 2189