Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 3. Check the input signal by using service data of the SWS monitor.
Check the input signals from the following switches:
-
Ignition switch: OFF
-
Driver's and front passenger's door: open
Select "ETACS-ECU" (DATA LIST), and check that normal conditions are displayed on the items described in the table.
Q: Does the scan tool display the items "IG SW (IG1)", "DR DOOR SW" and "PASS DOOR SW" as normal condition?
YES: Go to Step 4.
NO:
-
Normal condition is not displayed for "IG SW (IG1)": Refer to Inspection Procedure O-2 "ETACS-ECU does not receive a signal from the
ignition switch (IG1)."
-
Normal condition is not displayed for "DR DOOR SW" and "P/S DOOR SW: Refer to Inspection Procedure O-6 "ETACS-ECU does not receive
a signal from the driver's or the front passenger's door switch."
STEP 4. Check the input signal by using the Pulse check.
Check the input signals from the following switches:
