Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
2. The theft-alarm indicator light should illuminate when terminal 74 is grounded.
Q: Does the theft-alarm indicator light illuminate?
YES: Go to Step 9.
NO: Go to Step 3.
STEP 3. Check the theft-alarm indicator light.
1. Remove the combination meter. Refer to combination meter.
2. Disconnect combination meter connector C-42.
3. The theft-alarm indicator light should illuminate when battery voltage is applied between terminals 31 and 32.
Q: Does the theft-alarm indicator light illuminate?
YES: Go to Step 4.
NO: Replace the theft-alarm indicator light. The theft-alarm indicator light should illuminate, and the theft-alarm system should be set
normally.
STEP 4. Check at combination meter connector C-42 in order to check the battery power supply line to the theft alarm indicator light circuit.
1. Disconnect combination meter connector C-42, and check at the wiring harness side.
2. Measure the voltage between terminal 32 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES: Go to Step 7.
