mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2215 > < Initial Inspection and Diagnostic Overview|Page 2213
Page 298
background image

STEP 12. Check the horn relay.

Q: Is the horn relay normal?

YES: Go to Step 13.

NO: Replace the horn relay. All the vehicle horn (including the theft-alarm horn) should sound when the theft-alarm system is triggered.

STEP 13. Measure at horn relay connector A-05X in order to check the battery power supply system to the horn relay.

1. Disconnect horn relay connector A-05X, and measure at the relay box side.

2. Measure the voltage between terminal numbers 1, 2 and ground.

-

The measured value should be approximately 12 volts (battery positive voltage).

Q: Does the measured voltage correspond with this range?

YES: Go to Step 16.

NO: Go to Step 14.

STEP 14. Check horn relay connector A-05X for damage.

Q: Is horn relay connector A-05X in good condition?

YES: Go to Step 15.

NO: Repair or replace the connector. Refer to Harness Connector Inspection. All the vehicle horn (including the theft-alarm horn) should sound when
the theft-alarm system is triggered.

Initial Inspection and Diagnostic Overview|Page 2215 > < Initial Inspection and Diagnostic Overview|Page 2213