Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 6. Check the passenger's door switch.
Remove the passenger's door switch. Then check the continuity between the switch terminals and the switch body.
Q: Is the passenger's door switch in good condition?
YES: Go to Step 7.
NO: Replace the passenger's door switch. If the functions, which are described in "CIRCUIT OPERATION", work normally, the input signal from the
passenger's door switch should be normal.
STEP 7. Measure at the lower metal part of the passenger's door switch in order to check the ground circuit to the passenger's door switch.
NOTE: Check that the passenger's door switch is grounded to the vehicle body by means of its mounting screw. Remove the cap, and measure the
resistance value between the lower metal part and the ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 8.
NO: Check the fit of the switch, and repair if necessary. If the functions, which are described in "CIRCUIT OPERATION", work normally,
the input signal from the passenger's door switch should be normal.
