Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
NO: Replace the ETACS-ECU. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input signal from the
column switch (windshield wiper and washer switch) should be normal.
Inspection Procedure O-9
Column Switch: ETACS-ECU does not receive Any Signal from the Windshield Intermittent Wiper Interval Adjusting Knob.
NOTE: This troubleshooting requires use of scan tool MB991502 and SWS monitor kit MB991862. For details of how to use the SWS monitor, refer
to "How to use SWS monitor."
Windshield Intermittent Wiper Interval Adjusting Knob Input Circuit
CIRCUIT OPERATION
The ETACS-ECU calculates the windshield intermittent wiper interval according to the position of the windshield intermittent wiper interval adjusting
knob, which is incorporated in column switch (windshield wiper and washer switch).
TECHNICAL DESCRIPTION (COMMENT)
If the windshield intermittent wiper interval cannot be adjusted, the column switch or the ETACS-ECU may be defective.
TROUBLESHOOTING HINTS
-
Malfunction of the column switch (windshield wiper and washer switch)
-
Malfunction of the ETACS-ECU
-
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tools:
-
MB991223: Test Harness Set
-
MB991502: Scan Tool (MUT-II)
-
MB991862: SWS Monitor Kit
