Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 3. Check hazard warning light switch connector C-10 for damage.
Q: Is hazard warning light switch connector C-10 in good condition?
YES: Go to Step 4.
NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the equipment, which are described in "CIRCUIT OPERATION",
work normally, the input signal from the hazard warning light switch should be normal.
STEP 4. Check the wiring harness between hazard warning light switch connector C-10 and ground.
Q: Is the wiring harness between hazard warning light switch connector C-10 and ground in good condition?
YES: No action to be taken.
NO: Repair the wiring harness. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input signal from the hazard
warning light switch should be normal.
