Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
STEP 1. Check the hood switch.
Remove the hood switch. Refer to Hood. Then check continuity between the switch terminals.
Q: Is the hood switch in good condition?
YES: Go to Step 2.
NO: Replace the hood switch. If the theft-alarm system operates normally, it indicates that a correct signal is sent from the hood switch.
STEP 2. Measure at hood switch connector A-23 in order to check the ground circuit to the hood switch.
1. Disconnect hood switch connector A-23, and measure at the wiring harness side.
2. Measure the resistance value between terminal 1 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES: Go to Step 5.
NO: Go to Step 3.
