mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2316 > < Initial Inspection and Diagnostic Overview|Page 2314
Page 399
background image

STEP 6. Check the harness wires between the liftgate lock key cylinder switch <ECLIPSE> or the trunk lid lock key cylinder switch <ECLIPSE
SPYDER> connector F-10 and ETACS-ECU connector C-117.

NOTE:  After checking intermediate connector C-90, check the wires. If intermediate connector C-90 is damaged, repair or replace it. Refer to Harness
Connector Inspection.

Q: Are the harness wires between the liftgate lock key cylinder switch <ECLIPSE> or the trunk lid lock key cylinder switch <ECLIPSE SPYDER>
connector F-10 and ETACS-ECU connector C-117 in good condition?

YES: Replace the ETACS-ECU. When the theft-alarm system operates normally, check that the signal is input normally from the liftgate lock key
cylinder switch <ECLIPSE> or the trunk lid lock key cylinder switch <ECLIPSE SPYDER>.

NO: Repair them. When the theft-alarm system operates normally, check that the signal is input normally from the liftgate lock key cylinder switch
<ECLIPSE> or the trunk lid lock key cylinder switch <ECLIPSE SPYDER>.

Inspection Procedure P-11

ETACS-ECU does not Receive a Signal from the Vehicle Speed Sensor. <M/T>

Initial Inspection and Diagnostic Overview|Page 2316 > < Initial Inspection and Diagnostic Overview|Page 2314