mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2318 > < Initial Inspection and Diagnostic Overview|Page 2316
Page 401
background image

TROUBLESHOOTING HINTS

-

Malfunction of the vehicle speed sensor

-

Malfunction of the ETACS-ECU

-

Damaged harness wipes or connectors

DIAGNOSIS

 
Required Special Tools:

-

MB991223: Test Harness Set

-

MB991502: Scan Tool (MUT-II)

STEP 1. Check that the combination meter (speedometer) works normally.

Q: Does the combination meter (speedometer) work normally?

YES: Go to Step 2.

NO: Refer to Inspection Procedure O-8 "ETACS-ECU does not receive a signal from the windshield mist switch."

STEP 2. Check ETACS-ECU connector C-118 and vehicle speed sensor connector B-39 for damage.

Q: Are ETACS-ECU connector C-118 and vehicles speed sensor connector B-39 in good condition?

YES: Go to Step 3.

NO: Repair or replace the connector. Refer to Harness Connector Inspection. If the wiper interval can be adjusted normally, it indicates that the
windshield intermittent wiper interval adjusting knob should send a signal to the ECU.

Initial Inspection and Diagnostic Overview|Page 2318 > < Initial Inspection and Diagnostic Overview|Page 2316