Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
Throttle Position Sensor: Adjustments
Required Special Tools:
-
MB991502: Scan Tool (MUT-II)
-
MB991348: Test Harness Set
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting the scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector. When not using scan tool follow the steps below.
1. Disconnect the throttle position sensor connector, and connector the special tool MB991348 in between. (All terminals should be connected. )
2. Connect a digital voltmeter between throttle position sensor terminal 3 (sensor output) and terminal 1 (sensor ground).
2. Turn the ignition switch to the "ON" position (but do not start the engine).
3. Check the throttle position sensor output voltage.
Standard value: 535 - 735 mV
