Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
14.
The MUT-II will display this screen as it reprograms the PCM. It will take approximately 15 minutes to complete.
CAUTION
DO NOT DISTURB THE HARNESS CABLES OR CONNECTIONS. INTERRUPTION DURING THE PROGRAMMING PROCESS COULD
CAUSE THE PCM TO LOSE DATA OR PREVENT FUTURE PCM REPROGRAMMING.
15.
When the screen displays "Completed," press "C".
If reprogramming does not complete, turn the key off and repeat this process from Step 7.
To verify that the correct reprogramming has been made, the ROM ID number will display on the MUT-II screen. Note this number. The table in
Attachment A lists the ECU part numbers and ROM ID numbers that should display after reprogramming, and their corresponding vendor
numbers.
16.
Turn the ignition key to OFF and disconnect the MUT-II. Reprogramming is complete.
THE FOLLOWING STEPS ARE REQUIRED BY LAW.
17.
Using a ball-point pen, enter the appropriate PCM part number, vendor number, ROM ID #, this TSB number (TSB-02-13-017), your dealer code,
and the current date on the Engine Compartment Label (part no. MSSF-024G-00).
18.
Carefully remove all dirt and oil from a vacant area near the VECI label on the underside of the hood, and affix the Engine Compartment label.