Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
1. Remove the air bag module mounting screws (TORX © screws) at the sides of the steering wheel.
NOTE: Do not remove the screws from the holders.
WARNING: The removed air bag module should be stored in a clean, dry place with the pad cover face up.
CAUTION: When disconnecting the air bag module-to-clock spring connector, take care not to apply excessive force to it.
2. When disconnecting the connector of the clock spring from the air bag module, press the air bag's lock toward the outer side to spread to open.
Use a fiat-tipped screwdriver, as shown in the figure, to pry gently to remove the connector.
[[C]] STEERING WHEEL REMOVAL
CAUTION: Do not hammer on the steering wheel. Doing so may damage the collapsible column mechanism.
[[D]] CLOCK SPRING REMOVAL
WARNING: The removed clock spring should be stored in a clean, dry place.
[[E]] PASSENGER'S (FRONT) AIR BAG MODULE REMOVAL
WARNING: The removed airbag module should be stored in a clean, dry place with the pad cover face up.
INSTALLATION SERVICE POINTS
]]A[[ PRE-INSTALLATION INSPECTION
WARNING: Dispose of air bag modules only according to the specified procedure.
1. When installing the new air bag modules and clock spring, refer to "INSPECTION."
2. Connect the negative (-) battery cable.
