Eclipse RS L4-2350cc 2.4L SOHC MFI (2002)
10. Raise the window glass to the extreme position.
11. Turn the adjusting bolt until the gap between the delta sash assembly and the window glass end meets the shown dimension.
12. Lower the window glass.
13. Lock the adjusting bolt of the delta sash assembly with a nut
14. Tighten the two upper bolts at the delta sash assembly.
CAUTION: Ensure that the weatherstrip is not wrinkled or out of position.
15. Install the drip line weatherstrip to the weatherstrip holder. <ECLIPSE>
16. Install the topstack rail weatherstrip to the weatherstrip holder. <ECLIPSE SPYDER>
17. Install the door trim and the waterproof film
18. Check the door window glass alignment according to following procedure.
1. Close the door window glass fully, and close the door until the clearance between the door window glass rear end and the weatherstrip reaches
100 mm (3.9 inches). At this time, the distance between the rear end of the belt line molding outer and the quarter panel should be 113.5 -
118.5 mm (4.46 - 4.67 inches) <ECLIPSE> and 126 - 130 mm (4.9 - 5.1 inches) <ECLIPSE SPYDER>.
