mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Refrigerant Oil > < Refrigerant Leak Repair|Page 814
Page 4
background image

NOTE:  Refer to that Refrigerant Recovery and Recycling Unit Instruction Manual for operation of the unit.

DISCHARGING SYSTEM

Use the refrigerant recovery unit to discharge refrigerant gas from the system.

NOTE:  Refer to that Refrigerant Recovery and Recycling Unit Instruction Manual for operation of the unit.

REFILLING OF OIL IN THE A/C SYSTEM

Too little oil will provide inadequate compressor lubrication and cause a compressor failure. Too much oil will increase discharge air temperature.
When a compressor is installed at the factory, it contains 170 cubic cm (5.7 fl.oz.) <2.0L Engine (Turbo) and 2.4L Engine> 100 cubic cm (3.4 fl.oz.)
<2.0L Engine (Non-turbo)> of refrigerant oil. While the A/C system is in operation, the oil is carried through the entire system by the refrigerant.
Some of this oil will be trapped and retained in various parts of the system. When the following system components are changed, it is necessary to add
oil to the system to replace the oil being removed with the component.

Compressor oil: ND-OIL 8

Quantity

Evaporator: 40 cubic cm (1.35 fl.oz.)
Condenser: 40 cubic cm (1.35 fl.oz.)
Suction hose: 10 cubic cm (0.34 fl.oz)
Receiver: 10 cubic cm (0.34 fl.oz.)

Refrigerant Oil > < Refrigerant Leak Repair|Page 814