mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Quarter Window Glass > < Front Door Window Glass|Adjustments|Page 5686
Page 4
background image

and fully open.

NOTE:  If there is no clearance, the glass will be damaged. If the clearance is too great, rattling noise will occur.

5. The glass catch and the weather strip should be parallel with the door glass and the two up-stops should touch simultaneously when the glass is

fully closed.

6. Check the amount of glass tilt by the following procedure. <ECLIPSE>

Close the door glass fully and then gently close the door. Check that the difference in height between the door and side panels is 15 - 20 mm
(0.59 - 0.79 in.)
 when the corner of the door glass is touching the weather strip at the top of the center pillar.

NOTE:  If the amount of tilt is too small, the glass catch will move above the glass when the door is closed and when the glass is raised. If the
amount of tilt is too large, the door will be difficult to close and the glass will not be fully sealed when the door is closed.<ECLIPSE
SPYDER> Refer quarter window glass adjustment.

12. Install the waterproof film and the door trim.

Quarter Window Glass > < Front Door Window Glass|Adjustments|Page 5686