Eclipse Spyder FWD L4-2350cc 2.4L SOHC 16 Valve (1996)
5.
If leak is still present, add a rear stuffer from kit. Add a few drops of weatherstrip adhesive on the outer edge of the rear portion of the
stuffer and insert up through the lower portion of the rear rail weatherstrip. Hold the stuffer against the weatherstrip briefly to allow
adhesive to set. Lift the front of the stuffer in the area of the weatherstrip drain hole (at the front of the weatherstrip). Place a small
amount of adhesive between the stuffer and the weatherstrip, then hold the stuffer against the weatherstrip to set the adhesive. Repeat
for the other side.
6.
Close the convertible top then water test the vehicle to verify repair.
7.
If a leak is still present, then adjust the quarter-glass. See quarter-glass adjustment hints at the end of this bulletin.
PARTS INFORMATION
Required for procedures in this bulletin:
Stuffer Kit, Part Number MR311150
WARRANTY INFORMATION
