Eclipse Spyder FWD L4-2350cc 2.4L SOHC 16 Valve (1996)
REMOVAL SERVICE POINT
CLIP REMOVAL
(1) Use a Phillips-head screwdriver to push inward the pin (at the center of the clip) to a depth of about 2 mm (.08 in.).
(2) Pull the clip outward to remove it.
CAUTION Do not push the pin inward more than necessary because it may damage the grommet, or the pin may fall in, if pushed too far.
INSTALLATION SERVICE POINTS
COOLING UNIT INSTALLATION
When replacing the cooling unit with new one, refill the evaporator with a specified amount of compressor oil.
<2.0L Engine (Turbo) and 2.4L Engine>
Compressor oil: SUN PAG 56
Quantity: 60 cm3 (2.03 fl.oz.)
<2.0L Engine (Non-turbo)>
Compressor oil: ND-OIL 8
Quantity: 40 cm3 (1.35 fl.oz.)
CLIP INSTALLATION
(1) With the pin pulled out, insert the clip into the hole.
(2) Push the pin inward until the pin's head is flush with the grommet.
