Eclipse Spyder FWD L4-2350cc 2.4L SOHC 16 Valve (1996)
9. When not using the scan tool, proceed as follows:
(1) Disconnect the throttle position sensor connectors and connect the special tool. Test harness set, between the disconnected connectors.
(2) Connect a digital Voltmeter between the throttle position sensor terminal 2 (sensor output) and terminal 4 (sensor ground.)
10. Turn the ignition switch ON (but do not start the engine).
11. Check the throttle position sensor output Voltage. Standard value: 400-1,000 mV
12. If there is a deviation from the standard value, check the throttle position sensor and the related harness.
13. Remove the feeler gauge.
14. Switch OFF the ignition switch.