Eclipse Spyder FWD L4-2350cc 2.4L SOHC 16 Valve (1996)
Ignition Control Module: Testing and Inspection
NOTE: An analog-type circuit tester should be used.
Ignition Power Transistor Check
Ignition Power Transistor Check - Chart
No. 1 - No. 4 coil side
1. Connect the negative (-) terminal of the 1.5 V power supply to terminal (3) of the ignition power transistor and then check whether there is
continuity between terminal (8) and terminal (3) when terminal (7) and the positive (+) terminal are connected and disconnected.
NOTE: Connect the (-) probe of the circuit tester to terminal (13).
2. Replace the ignition power transistor if there is a malfunction.
Ignition Power Transistor Check
Ignition Power Transistor Check - Chart
No. 2 - No. 3 coil side
1. Connect the negative (-) terminal of the 1.5 V power supply to terminal (3) of the ignition power transistor; and then check whether there is
continuity between terminal (1) and terminal (3) when terminal (2) and the positive (+) terminal are connected and disconnected.
NOTE: Connect the (-) probe of the circuit tester to terminal (12).
2. Replace the ignition power transistor if there is a malfunction.