Eclipse Spyder FWD L4-2350cc 2.4L SOHC 16 Valve (1996)
6.
Remove the sunroof drive motor.
Perform steps 7 through 14 for one side at a time.
7.
Remove the guide rail rod holder as follows:
a.
Manually move the sunroof frame to the appropriate position to allow the guide rail rod holder to be removed.
b.
Remove the two guide rail rod holder attaching screws at the front of the sunroof.
c.
Tilt the upper portion of the guide rail to the inside, then remove the guide rail rod holder.
8.
Remove the drive cable from the guide rail by first pulling the cable up, then pulling the cable out from the guide rail.
9.
Inspect the drive cable. If the cable is wet, dry with a soft cloth. If rust is visible on the cable, replace the cable with the appropriate part listed in
the PARTS INFORMATION section of this bulletin.
10.
Using a small brush, apply a water insoluble grease (Loctite SuperLube 82328 or equivalent) to the surfaces of the cable. Be sure to thoroughly
coat the entire cable surface.
11.
Reinstall the drive cable.
12.
Apply butyl rubber (3M Part No. 8610 or equivalent) between the guide rail rod holder and the rail as shown. Be sure to make a complete seal
around the drain tubes.
13.
Remove any excess grease from the sunroof, guide rail and drive motor.
