Eclipse Spyder GS-T FWD L4-1997cc 2.0L DOHC Turbo MFI (1997)
REMOVAL SERVICE POINT
<A> CLIP REMOVAL
1. Use a Phillips-head screwdriver to push inward the pin (at the center of the clip) to a depth of about 2 mm (0.08 in.).
2. Pull the clip outward to remove it.
CAUTION: Do not push the pin inward more than necessary be- cause it may damage the grommet or the pin may fall in, if pushed too far.
INSTALLATION SERVICE POINTS
>A< COOLING UNIT INSTALLATION
When replacing the cooling unit with new one, refill the evaporator with a specified amount of compressor oil.
Compressor oil: SUN PAG 56
Quantity: 60 cubic cm (2.03 fl.oz.)
>B< CLIP INSTALLATION
1. With the pin pulled out, insert the clip into the hole.
2. Push the pin inward until the pin's head is flush with the grommet.
DISASSEMBLY AND REASSEMBLY