Eclipse Spyder GS-T FWD L4-1997cc 2.0L DOHC Turbo MFI (1997)
Fuel Pressure: Testing and Inspection
1. Release residual pressure from the fuel line.
2. Disconnect the high-pressure fuel hose at the fuel rail side.
CAUTION: Cover the hose with a shop towel not to let pressurized fuel gush out.
3. Remove the union joint and bolt from the special tool (adapter hose MD9987O9) and instead attach the special tool (hose adapter MD998742) to
the adapter hose.
4. Install a fuel pressure gauge on the adapter hose that was set up in step 3.
Use a suitable O-ring or gasket between the fuel pressure gauge and the special tool so as to seal in order to prevent fuel leakage at this time.
5. Install the special tool, which was assembled in steps 3 and 4 between the fuel rail and the high pressure hose.
6. Connect the fuel pump drive terminal to the battery (+) terminal using a jumper wire to drive the fuel pump. Check the fuel pressure gauge and
special tool connections for leaks.
7. Disconnect the jumper wire from the fuel pump drive terminal to stop the fuel pump.
8. Stan the engine and run at idle.
