Eclipse Spyder GS L4-2350cc 2.4L SOHC MFI (2001)
2.
Connect the new jumper harness to the power seat switch connector. Connect the other end of the new harness to the floor harness.
3.
Place the jumper harness/floor harness connector under the capacitor and secure it to the floor harness in two locations with electrical tape.
NOTE:
Use at least three turns of electrical tape in each area when securing the jumper harness to the floor harness.
4.
Check for proper operation of the power seat. Make sure that there is no interference between the jumper harness and the seat frame when the seat
is moving. Verify that there is no speaker noise when the seat is moving.
1999-2001 Galant
1.
Move the driver's seat all the way to the back of its travel. Locate and disconnect the power seat switch connector under the driver's seat.
2.
Connect the new jumper harness to the floor harness connector.
