Eclipse Spyder GS L4-2350cc 2.4L SOHC MFI (2001)
2. Fill the washer tank with water.
3. Check that the water squirts out strongly when battery positive voltage is applied to terminals 1 and 2.
Q: Is the washer motor In good condition?
YES: Go to Step 5.
NO: Replace it. The windshield washer should work normally.
STEP 5. Check the washer motor ground circuit at the washer motor connector A-33.
1. Disconnect the washer motor connector A-33 and measure at the harness side.
2. Measure the resistance between terminal 2 and ground.
Q: Is the resistance between terminal 2 and ground less than 2 ohm?
YES: Go to Step 8.
NO: Go to Step 6.
STEP 6. Check washer motor connector A-33 for damage.
Q: Is washer motor connector A-33 In good condition?
YES: Go to Step 7.
NO: Repair or replace it. Refer to Harness Connector Inspection. The windshield washer should work normally.
STEP 7. Check the harness wire between washer motor connector A-03 and ground.
Q: Is the harness wire between washer motor connector A-33 and ground in good condition?
