mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2202 > < Initial Inspection and Diagnostic Overview|Page 2200
Page 143
background image

1. Disconnect the theft-alarm horn relay connector A-11X and measure at the relay box side.
2. Measure the voltages between terminals 3, 5 and ground.

Q: Are the voltages approximately 12 volts (battery positive voltage)?

YES: Go to Step 7.

NO: Go to Step 5.

STEP 5. Check the theft-alarm horn relay connector A-11X for damage.

Q: Is theft-alarm horn relay connector A-11X in good condition?

YES: Go to Step 6.

NO: Repair or replace it. Refer to Harness Connector Inspection. The horn should sound when the theft-alarm system is triggered.

Initial Inspection and Diagnostic Overview|Page 2202 > < Initial Inspection and Diagnostic Overview|Page 2200