Eclipse Spyder GS L4-2350cc 2.4L SOHC MFI (2001)
STEP 3. Check the harness wire between column switch connector C-86 and ETACS-ECU connector C-111.
Q: Is the harness wire between column switch connector C-86 and ETACS-ECU connector C-111 in good condition?
YES: Go to 4.
NO: Repair it. Check that the input signal from the windshield intermittent wiper interval adjusting knob can be checked and the wiper interval can be
adjusted.
STEP 4. Replacement of ECU
1. Replace the ETACS-ECU.
2. Check that the input signal from the windshield intermittent wiper interval adjusting knob can be checked and the wiper interval can be adjusted.
Q: Is the input signal from the windshield intermittent wiper interval adjusting knob input normally?
YES: There is no action to be taken.
NO: Replace the column switch. Check that the input signal from the windshield intermittent wiper interval adjusting knob can be checked and
the wiper interval can be adjusted.
Inspection Procedure O-20
Sunroof Switch: the Open, Close/Tilt-Down, or Tilt-Up Switch Signal Is Not Sent to the ETACS-ECU
