Eclipse Spyder GS L4-2350cc 2.4L SOHC MFI (2001)
6. Place three old tires without wheels on top of the tire secured to the air bag module, and secure all tires together with ropes (four locations).
WARNING:
-
Before deployment, check carefully to be sure that no one is nearby.
-
The inflator will be quite hot immediately following the deployment, so wait at least 30 minutes to allow it to cool before attempting to
handle it. Although not poisonous, do not Inhale gas from air bag deployment. See Deployed Air Bag Module Disposal Procedures to
post-deployment handling instructions.
-
If the air bag falls to deploy, do not go near the module. Contact the MMSA Tech Line.
7. At a location as far away from the air bag module as possible, and from a shielded position, disconnect the two connected wires from each other,
and connect them to the two terminals of the battery (which has been removed from the vehicle) to deploy the air bag.
8. Discard the deployed air bag module as specified in Deployed Air Bag Module Disposal Procedures.
Front Passenger's Side
Before disposing of an air bag or a vehicle equipped with an air bag, follow the procedures below to deploy the air bag.
Required Special Tools:
MB628919 or MR203491: SRS Air Bag Adapter Harness C
MB686560: SRS Air Bag Adapter Harness B
MR372530: SRS Air Bag Adapter Harness A
WARNING:
-
If the vehicle is to be scrapped or otherwise disposed of, deploy the air bags inside the vehicle. If the vehicle will continue to be used and
only the air bag modules are to be disposed of, deploy the air bags outside the vehicle.
-
Since a large amount Of smoke is produced when the air bag is deployed, avoid residential areas whenever possible.
-
Since there is loud noise when the air bags are deployed, avoid residential areas whenever possible. If anyone is nearby, give warning of
the impending noise.
-
Suitable ear protection should be worn by personnel performing these procedures or by people in the immediate area.
DEPLOYMENT OUTSIDE THE VEHICLE <Air bag module (front passenger's side.)>
DANGER: Wait at least 60 seconds after disconnecting the battery cables before doing any further work.
WARNING:
-
Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDING.
-
Deploy the air bag in a wide, flat area at least 6 meters (20 feet) away from obstacles and other people.
-
Do not perform deployment outside if a strong wind is blowing. If there is a slight breeze, place the air bag module downwind from the
battery.
1. Disconnect the negative (-) and positive (+) battery cables from the battery terminals, and then remove the battery from the vehicle.
WARNING: Store the air bag module on a flat surface with the pad cover facing up. Do not place anything on top of it.
2. Remove the air bag module from the vehicle.
