Eclipse Spyder GS L4-2350cc 2.4L SOHC MFI (2001)
4. Using special tool MB991007, drive in the dust cover plate until it contacts the projection of the ball joint.
5. Check the dust cover for cracks or damage by pushing it with your finger.
LOWER ARM REAR BUSHING REPLACEMENT
1. Position the lower arm bushing so that its arrow mark point the shown direction.
2. Use the special tool MB991446 to press in the bushing to the shown dimension.
BALL JOINT DUST COVER REPLACEMENT
If the dust cover is damaged accidentally during service work, replace the dust cover as follows:
1. Remove the dust cover.
2. Apply multipurpose grease to the lip and inside of the dust cover.
3. Using special tool MB990799, drive in the dust cover until it is fully seated.
4. Using special tool MB991007, drive in the dust cover plate until it contacts the projection of the ball joint.
5. Check the dust cover for cracks or damage by pushing it with your finger.
