Endeavor V6-3.8L SOHC (2004)
NO : Repair the wiring harness. The multi-center display unit (middle grade type) should work normally.
STEP 7. Check the multi-center display unit (middle grade type) power supply circuit [ignition switch (ACC)]. Measure the voltage at the
multi-center display unit (middle grade type) connector C-06.
1. Disconnect the multi-center display unit (middle grade type) connector C-06 and measure at the harness side.
2. Turn the ignition switch to "ACC" position.
3. Measure the voltage between terminal 3 and ground by backprobing.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES : Go to Step 10.
NO : Go to Step 8.
STEP 8. Check multi-center display unit (middle grade type) connector C-06 for loose, corroded or damaged terminals, or terminals pushed
back in the connector.
Q: Is multi-center display unit (middle grade type) connector C-06 in good condition?
YES : Go to Step 9.
NO : Repair or replace the connector. Refer to Harness Connector Inspection. The multi-center display unit (middle grade type) should work
normally.
