Endeavor V6-3.8L SOHC (2004)
2. Measure the resistance between terminal 6 and ground.
-
The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with this range?
YES : Go to Step 4.
NO : Go to Step 2.
STEP 2. Check the multi-center display unit (low grade type) connector C-06 for loose, corroded or damaged terminals, or terminals pushed
back in the connector.
Q: Is the multi-center display unit (low grade type) connector C-06 in good condition?
YES : Go to Step 3.
NO : Repair or replace the connector. Refer to Harness Connector Inspection.
STEP 3. Check the wiring harness between multi-center display unit (low grade type) connector C-06 (terminal 6) and ground.