Endeavor V6-3.8L SOHC (2004)
NOTE: After checking joint connector (2) C-104 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If joint
connector (2) C-104 is damaged, repair or replace the wiring harness. Refer to Harness Connector Inspection.
Q: Is the wiring harness between multi-center display unit (low grade type) connector C-06 (terminal 6)and ground in good condition?
YES : There is no action to be taken.
NO : Repair the wiring harness. The multi-center display unit (low grade type) should work normally.
STEP 4. Measure the voltage the multi-center display unit (low grade type) power supply circuit (battery) at the multi-center display unit (low
grade type) connector C-06.
1. Disconnect the multi-center display unit (low grade type) connector C-06 and measure at the harness side.
2. Measure the voltage between terminal 1 and ground.
-
The measured value should be approximately 12 volts (battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES : Go to Step 7.
NO : Go to Step 5.
STEP 5. Check multi-center display unit (low grade type) connector C-06 for loose, corroded or damaged terminals, or terminals pushed back
in the connector.
