Endeavor V6-3.8L SOHC (2004)
The rear ABS sensor can be damaged during service work. Unclamp the rear ABS sensor cable as shown, and tie it out of the way.
<<B>> TOE CONTROL ARM ASSEMBLY REMOVAL
Disconnect the toe control arm only from its rear suspension crossmember side, and tie it to the trailing arm assembly as shown.
<<C>> CROSSMEMBER STAY REMOVAL
The crossmember mounting bolts need not be unscrewed when the crossmember stay is replaced. However, the bolts may be loose while the
crossmember stay is removed. It is recommended that you should retighten the bolts to 100 ± 10 Nm (74 ± 7 ft. lbs.).
INSTALLATION SERVICE POINTS
>>A<< CROSSMEMBER STAY INSTALLATION
Install the crossmember stay with its arrow facing the front of vehicle.
>> B<< CROSSMEMBER STAY/CROSSMEMBER NUT INSTALLATION