Endeavor V6-3.8L SOHC (2004)
6.
Remove the wiring connector clips from the harness bracket. Note the location of each clip for reassembly. On power seal models, use care to
avoid bending the drive cable.
7.
Remove the eight nuts securing the riser to the adjuster.
8.
Replace the riser with the new, improved riser listed in the PARTS INFORMATION section of this bulletin.
a.
Secure the new riser to the seat adjuster, using the new nuts provided in the repair kit. Torque Specification: 8.8 +/- 1 Nm (6.5 + 1 ft/lb)
9.
Reinstall the wiring connector clips.
CAUTION
On power seat models, be sure the harness is properly routed and re-connected in its original position. Incorrect harness routing can result in
harness damage during operation.
