Endeavor V6-3.8L SOHC (2004)
Seat Track: Customer Interest
Interior - Poor Power Seat Operation/Noise When Operated
No: TSB-10-52A-002
DATE: March, 2010
MODEL: See below
SUBJECT:
NOISE AND POOR OPERATION OF POWER SEAT
This TSB supercedes TSB-05-52A-002, issued November, 2005, to add affected vehicles and revise repair instructions. Revised information is shown
with a <.
PURPOSE <
If the driver's power seat adjustment does not operate properly or exhibits noise, inspect the drive cable using step 1 of the PROCEDURE section of this
TSB. If you determine the drive cable is damaged (bent or broken), replace it with the new cable listed in the PARTS INFORMATION section of this
bulletin.
**IMPORTANT**
Do not replace the seat assembly for a drive cable issue. Warranty claims for seat assembly replacement for a damaged drive cable are subject to charge
back.
Follow the instructions in this bulletin for diagnosing and replacing the seat adjuster drive cable.
AFFECTED VEHICLES <
2004-on Endeavor and Galant models equipped with power seats
2006-on Eclipse models equipped with power seats
2007-on Eclipse Spyder models equipped with power seats
PROCEDURE <
1. Raise the seat to its highest position, and move it rearward to allow access to the cable.
2. To determine if a drive cable is damaged internally, (some will not show external damage), hold it while operating the seat switch. It may be necessary
to slightly flex the cable while the motor is operated. If the noise is dampened or eliminated, replace the cable.
